CR1151
10
4.3.2 Installation with installation kit
The installation kit enables horizontal, vertical or overhead mounting of the device in a panel cut-out.
This type of mounting is suited for materials with a thickness from 1 to 10 mm.
Longer set screws have to be used for material thicknesses >10 mm. They are not supplied with the
mounting accessories.
The fixing profile, spacers, M5 hexagon nuts, washers, M5 set screws and damping strips required for
mounting are supplied with the installation kit.
Fig. 2: Fixing profile of the installation kit
Fig. 3: Dialogue module with mounted installation kit
Use the fixing profile of the mounting kit only together with a suitable spacer and the damping
strip .
4.3.3 Panel cutout
u
Make a cut-out.
105
165
4 x R6
Fig. 4: Panel cut-out
Tolerances: ± 0.5 mm
4.3.4 Mounting steps
u
Screw the set screws into the M5 thread on the back of the device: Location for mounting
accessories (
7).
u
Attach damping strips to the device.
Fig. 5: Damping strips
u
Insert the device into the cut-out.
u
Insert the spacer suitable for the panel thickness. The thickness of the spacers corresponds to the
panel thickness. If necessary, use several spacers on top of each other.
