Process and dialogue module ecomatDisplay CR1058, CR1059
10
4.2.2 Light sensor and status LED
The device is equipped with a light sensor� This sensor is used for automatic
brightness adaptation of the display and the operating elements to the ambient
brightness�
1
2
1: Light sensor
2: Status LED
►
Do not cover up the light sensor by construction measures�
The status LED shows the operating states of the device�
4.3 Panel mounting / control cabinet installation
4.3.1 Safety instructions for panel mounting / control cabinet installation
The indications for the operating temperature apply equally in front of and
behind the installation level�
The dimensions for the control panel cut-out are a basic prerequisite for the
requirements concerning electrical protection, fire protection and protection
rating of the device / system� However, this alone does not ensure
compliance with the requirements� See the following safety instructions� The
system creator has to take them into consideration for the risk assessment
