IO-Link master with EtherCAT interface DataLine 4 ports IP 65 / IP 66 / IP 67
84
11
Maintenance, repair and disposal
Content
Cleaning process .................................................................................................................................... 84
Updating the firmware ............................................................................................................................ 84
Replacing IO-Link device ........................................................................................................................ 84
51990
The operation of the unit is maintenance-free.
► Dispose of the unit in an environmentally friendly way in accordance with the applicable national
regulations when it is no longer used.
11.1
Cleaning process
51991
► Clean the surface of the unit when necessary.
► Do not use any caustic cleaning agents for this!
► In case of severe soiling, use a damp cloth.
► Do not use any caustic cleaning agents for this!
>
11.2
Updating the firmware
61183
The firmware of the IO-Link master can be updated via the IoT Core Visualizer
→
Updating the
firmware
(
>
11.3
Replacing IO-Link device
34182
To replace an IO-Link device:
Requirement:
>
New IO-Link device is with factory settings.
>
New IO-Link device supports IO-Link standard 1.1 or higher.
1 Set data storage
►
Set the following parameters of the IO-Link port
▪
Set Validation and Data Storage to [Type compatible V1.1 device with Restore] or [Type compatible V1.1. device
with Restore]
▪
Set correct values to [Vendor ID] and [Device ID] according to properties of the IO-Link device.
►
Save changes.
2 Replace IO-Link device
►
Disconnect old IO-Link device from IO-Link master.
►
Connect new IO-Link device with the same IO-Link port of the AL1330.
>
IO-Link master copies parameter values from the data memory to the new IO-Link device.
>