4. Turn on the hot and cold and mains water supply. Check for leaks immediately. It
is always advisable at this stage to flush out the system. To do this, open both
valves fully and allow water to flow for approx.1 minute. This will remove any
foreign matter within the installation.
5. Finally turn on all the water heating arrangements.
Aftercare
Whilst modern plating techniques are used in the manufacture of these fittings, the
plating will wear if not cleaned properly. The safest way to clean your product is
to wipe with a soft damp cloth. Stains can be removed using washing up liquid.
All cleaning powders and liquids will damage the surface of your fitting even the
non-scratch cleaners.
INST NM36 (Rev.1.0)
4
Note: Tap head shown is for illustration purposes only.
1
2
3
4
5