9
6. Look under the Console Support (8) and identify
the Upper Wire (123), which has a larger con-
nector than the Extension Wire (124).
Connect the Upper Wire (123) to the Lower
Wire (122) extending from the Handlebar Post
(7).
Tip: The wire connectors should slide
together easily and snap into place with an
audible click. If they do not, turn one connec-
tor and try again.
Then, connect the Extension Wire (124) to
the Control Wire (125) extending from the
Handlebar (97) in the same way.
8
7
97
122
125
124
6
123
7. Have a second person hold the Console
(10) near the Console Bracket (11). Then,
route the wires (F) on the back of the
Console through the opening in the Console
Bracket as shown by the dashed line at the right.
See inset drawing a.
Connect the wires (D)
from the Console Support (8) to the match-
ing wires (F) on the back of the Console (10).
Tip: The wire connectors should slide
together easily and snap into place with an
audible click. If they do not, turn one connec-
tor and try again.
Tip: Avoid pinching the wires (F, D). If
necessary, adjust the tilt of the Console
Bracket (11) to make this step easier.
Attach
the Console (10) to the Console Bracket with
four M6 x 20mm Machine Screws (102);
start all
the Machine Screws, and then tighten them.
Then, tilt the Console (10) upward and
downward a few times.
If the up and down
movement feels too loose, see inset draw-
ing b.
Tighten the four M6 x 15mm Cap Screws
(157) in the Rear Bracket Mount (114) until the
up and down movement no longer feels loose.
Note: For clarity, the Console and the wires are
not shown. Tilt the Console upward and down-
ward to access the Cap Screws.
11
10
10
102
102
157
157
114
D
F
F
8
8
Avoid pinching
the wires (F, D)
7
a
b