IFD-NET EVO EMS USER MANUAL
rev. 121022EN
WWW
.IFD-NET.
COM
M.A.V.
AVIONIC DIVISION
V
IA
L
OMBARDIA
2,
25025
M
ANERBIO
(BS)
I
9
3.
UNIT
DESCRIPTION
The IFD-NET EVO EMS interface is based on a double concentric
rotary knob with a push switch that gives access to all the
settings the pilot needs during the flight, and allow to adjust
the setup’s parameters.
On the right side of this page is shown the main page of
instrument.
Spinning the big crown rotary knob will show other sensors (if
set) on the center-right part of the screen. Spinning the little
crown rotary knob will show other sensors (if set) on the low
part of the screen.
The pilot can access the main setup by keeping pressed the
knob for about 2 seconds until the screen, shown on the
right, appears.
Within setups, by rotating the little rotary knob’s crown,
moves the selection up and down, and tapping button
confirms the highlighted selection.
IFD-NET EVO is available in three different models:
VERSION
Thermocouples
Programmable
sensors
Impulsive input
MAP
BASE
6
6
3
1
FULL
12
12
3
1
DUAL ENGINE
12
12
3
2
In order to realize a network, IFD-NET EVO EMS can be classified in:
Master: It consists in a single unit witch capture and visualize various engine data and
generate a RS485 pack data that will be used from slaves connected to the bus.
Slave: The unit reads data from RS485 BUS