IFD-NET EVO EMS USER MANUAL
rev. 121022EN
WWW
.IFD-NET.
COM
M.A.V.
AVIONIC DIVISION
V
IA
L
OMBARDIA
2,
25025
M
ANERBIO
(BS)
I
27
6.
INSTALLATION
GUIDE
The IFD-NET EVO EMS model has a standard 80mm aeronautical shape and is intended to be installed into a standard
80mm hole (3.125’’).
This means the installer should observe the standard way in order to obtain a correct installation on the unit. Refer to
the hole templates below in case your aircraft doesn’t have 80mm holes already prepared.
To lock the IFD-NET EVO EMS (80mm) unit on your cockpit use the three black screws provided in the purchase box,
otherwise select different screws with same dimension of 4MA x 10mm MAX.
The IFD-NET EVO (80mm) is installable in a standard hole, keeping in account that the lower-right screw hole shall be
enlarged to a diameter of 7.5 mm to accommodate the rotary knob.
The screws on the remaining three holes shall be tightened with appropriate torque, in a way to keep the instrument
fixed and not introduce any vibration.
Remove the aluminum knob by turning on the little screw. This is because the encoder shaft needs to pass throw the
7.5mm diameter hole in the bottom right corner of the 80mm hole.
After putting the instruments in the reworked slot, install the aluminum knob and turn its screw to lock it; use a plastic
profile to obtain a thickness of about 1mm between the cockpit surface and the bottom part of the aluminum knob.
Use the provided 4mm MA black screws (length 10mm) to fix the instrument to the panel. Do not over-tighten the
screws in order to avoid damage to the IFD-NET chassis. Use a medium thread locker to ensure screws will not come
off due to vibrations.