EN
4 - HANDLING AND INSTALLATION
BOSS 552-IC
4 - Pag. 22 / 28
4.6
DEVICE FOR SLIDING HEADSTOCK LATHES - INSTALLATION
4.6.1 Bar-headstock synchronization device
• Open the upper guard.
INFORMATION:
the figure shows a general example of
installation; contact IEMCA service
department for more information.
• Loosen the "A" screw.
• Install the bar "B" and the tie rod "C", and make
sure that the headstock "D" can run freely
throughout its stroke together with shaft "E".
• Place the support "F" so that it does not hinder the
headstock stroke and tighten the screw "A".
Summary of Contents for BOSS 552 - IC
