IEI Technology WAFER-LX-800-R12, User Manual

Page: 82 / 227

WAFER-LX Motherboard
Page 64
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
ƒ
Turn off all power to the WAFER-LX:
o
When working with the motherboard, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before and during the installation of the WAFER-LX DO NOT do the following:
ƒ
DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
ƒ
DO NOT use the product before verifying all the cables and power connectors
are properly connected.
ƒ
DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
5.3 Unpacking
NOTE:
If any of the items listed below are missing when the WAFER-LX is
unpacked, do not proceed with the installation and contact the
WAFER-LX reseller or vendor.
5.3.1 Unpacking Precautions
Before installing the WAFER-LX, unpack the motherboard. Some components on
WAFER-LX are very sensitive to static electricity and can be damaged by a sudden rush
of power. To protect it from being damaged, follow these precautions:
ƒ
The user should ground them self to remove any static charge before
touching the WAFER-LX. To do so wear a grounded wrist strap at all times or
frequently touch any conducting materials that is connected to the ground.
ƒ
Handle the WAFER-LX by its edges. Do not touch the IC chips, leads or
circuitry if not necessary.