IEI Technology WAFER-JL-N5105, User Manual

Page: 37 / 79

WAFER-JL-N5105 SBC
Page 25
Pin Description
1 +3.3V
2 LAN3_LED_LNK#_ACT
Table 3-13: LAN3 LED Connector Pinouts
3.2.9 Battery Connector
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Only
certified engineers should replace the on-board battery.
Dispose of used batteries according to instructions and local
regulations.
NOTE:
It is recommended to attach the RTC battery onto the system chassis in
which the WAFER-JL-N5105 is installed.
CN Label:
BAT2
CN Type:
2-pin wafer, p=1.25 mm
CN Location:
See Figure 3-11
CN Pinouts:
See Table 3-14
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.