30
4.6 Auto-Detect
Hard
Disk
This option detects the parameters of an IDE hard disk drive (HDD sector, cylinder,
head, etc) automatically and will put the parameters into the Standard CMOS
Setup screen. Up to 4 IDE drives can be detected and the parameters will be listed
in the box. Press <Y> if you accept these parameters. Press <N> to skip the
next IDE drives.
Note: If your IDE HDD was formatted in previous older system, incorrect
parameters may be detected. In this case, you need to enter the correct
parameters manually or low-level format the disk.
4.7 Change Supervisor Password
This option sets a password that is used to protect your system and Setup Utility.
Supervisor Password has higher priority than User Password. Once you setup the
password, the system will always ask you to key-in password every time you enter
the BIOS SETUP. If you enter the BIOS SETUP with Supervisor Password, you can
choose every setup/option on the main menu but with User Password, you can only
choose three setup/options (USER PASSWORD, SAVE SETTING AND EXIT and EXIT
WITHOUT SAVING). To disable these passwords, enter the BIOS SETUP room with
Supervisor Password and then just press the <Enter> key instead of entering a
new password when the prompt 'Enter Password' pops up.
Note: If you forget the password, do the Clear/Reset CMOS procedure (see Part 2.3
the CPU Setting for WAFER-4821 >> Clear CMOS SETUP)
