background image

Software Driver / 

驅動程式安裝

 

All the drivers for the uIBX-250 are on the utility CD that came with the system. The utility CD 
contains drivers for Windows 7 and Windows 8 operating systems. Please select the 
corresponding drivers for the system. 

所有

  uIBX-250

的驅動程式均在隨貨附上的光碟內,其中包括

Windows 7 

  Windows 8 

作業系

統的驅動程式。請選擇對應的驅動程式來安裝。

 

 
NOTE:   
The content of the CD may vary throughout the life cycle of the product and is subject to change 
without prior notice. Visit the IEI website or contact technical support for the latest updates. 

光碟片的內容會根據產品生命週期而有所不同,若有變更,恕不另行通知。請至

IEI

官網或聯繫技

術人員以獲得最新的更新。

 

 

 
 
 
 
 
Compliance / 

安規

 

 

This equipment has been tested and found to comply with specifications for CE marking. If the user modifies 

and/or installs other devices in the equipment, the CE conformity declaration may no longer apply. 

 

 

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

 

This device may not cause harmful interference, and 

 

This device must accept any interference received, including interference that may cause undesired 

operation. 

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference 

when the equipment is operated in a commercial environment. This equipment generates, uses, and can 

radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may 

cause harmful interference to radio communications. Operation of this equipment in a residential area is likely 

to cause harmful interference in which case the user will be required to correct the interference at his own 

expense. 

 

 

 

 

According to the requirement of the WEEE legislation the following user information is provided to customers 

for all branded IEI Electronics products subject to the WEEE directive. 

This symbol on the product or on its packaging indicates that this product must not be disposed of with your 

other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over 

to a designated collection point for the recycling of waste electrical and electronic equipment. The separate 

collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources 

and ensure that it is recycled in a manner that protects human health and the environment. For more 

information about where you can drop o- your waste equipment for recycling, please contact your local city 

office, your household waste disposal service or the shop where you purchased the product. 

 

Summary of Contents for uIBX-250









Reviews: