IEI Technology TANK-870e-H110 Series, User Manual

Page: 27 / 110

TANK-870e-H110 Embedded System
Page 15
3.1 Installation Precautions
During installation, be aware of the precautions below:

Read the user manual : The user manual provides a complete description of
the TANK-870e-H110, installation instructions and configuration options.

DANGER! Disconnect Power : The TANK-870e-H110 has more than one
power supply connection point. To reduce the risk of electric shock,
disconnect all power sources during the installation process, or before any
attempt is made to access the rear panel. Electric shock and personal injury
might occur if the rear panel of the TANK-870e-H110 is opened while the
power cord is still connected to an electrical outlet.

Qualified Personnel : The TANK-870e-H110 must be installed and operated
only by trained and qualified personnel. Maintenance, upgrades, or repairs
may only be carried out by qualified personnel who are familiar with the
associated dangers.

Air Circulation : Make sure there is sufficient air circulation when installing
the TANK-870e-H110. The TANK-870e-H110’s cooling vents must not be
obstructed by any objects. Blocking the vents can cause overheating of the
TANK-870e-H110. Leave at least 5 cm of clearance around the
TANK-870e-H110 to prevent overheating.

Grounding : The TANK-870e-H110 should be properly grounded. The voltage
feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the TANK-870e-H110.
3.2 Hard Disk Drive (HDD) Installation
To install the hard drive, please follow the steps below:
Step 1: Loosen the two thumbscrews on the front panel, slide the cover outward, and
then lift the cover up gently ( Figure 3-1 ).