IEI Technology TANK-801-BT, User Manual

Page: 34 / 112

TANK-801 Em b e d d e d S ys te m
P a g e 22
S te p 1: Locate the DC-in terminal block connector. The location of the connector is
shown in Figure 1-2 .
S te p 2:
Align the pluggable DC-in terminal block with the DC-in terminal block connector
on the TANK-801.
S te p 3:
Once aligned, insert the pluggable DC-in terminal block into the DC-in terminal
block connector.
S te p 4: Secure the pluggable DC-in terminal block to the external interface by tightening
the two retention screws on either side of the terminal block ( Figure 3-9 ).
Figure 3-9: Pluggable DC-in Terminal Block Installation
3.6 Mo u n tin g th e S ys te m with Mo u n tin g Bra c ke ts
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
S te p 1:
Turn the embedded system to the left side panel.
S te p 2:
Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the left side panel ( Figure 3-10 ).