RACK-220G QIG
IEI Technology Corp. Page 6
Figure 12: Insert HDD Retention Screws
Step 4:
Once the HDD is secured, the HDD bracket can be
reinstalled. Correctly position the bracket making sure
the power connector and the IDE/SATA connector of
HDD face the backplane bracket and reinsert the four
previously removed retention screws.
Step 0:
S
TEP
8.2: FDD I
NSTALLATION IN THE
M
AIN
B
RACKET
The main drive bracket of RACK-220G chassis contains a front
accessible FDD drive bay. To install a FDD in the 3.5” front
accessible drive bay, please follow the steps below:
Step 1:
Remove the main drive bracket by removing the four
retention screws that connect it to the chassis.
Figure 13: Four Main Drive Bracket Retention Screws
Step 2:
Remove the front cover of the 3.5” drive bay by
removing the two front cover retention screws, one on
each side.
Figure 14: Front Accessible 3.5
＂
Drive Bracket Front
Cover Retention Screws
Step 3:
Correctly position a 3.5” drive into the correct bracket
locations. Make sure the power connector and the
IDE/SATA connector are at the rear of the main bracket.
Step 4:
The FDD is secured with four retention screws, two on
each side.
Figure 15:
Insert Four Retention Screws into FDD
Step 0:
Step 8.3: Optical Drive Installation in the Main
Bracket
The main drive bracket of RACK-220G chassis contains a front
accessible 5.25” optical drive bay. To install an optical drive in the
5.25” front accessible drive bay, please follow the steps below:
Step 1:
Remove the main drive bracket by removing the four
retention screws that connect it to the chassis.
Step 2:
Remove the front cover of the 5.25” drive bay by
removing the four front cover retention screws, two on
each side.
Figure 16: 5.25
＂
Optical Drive Bay Front Cover Retention
Screws
Step 3:
Correctly position a 5.25” optical drive into the optical
drive bay. Make sure the power connector and the
IDE/SATA connector are at the rear of the main bracket.
Step 4:
The 5.25” optical drive is secured with four retention
screws, two on each side.
