46
Appendix D: How to use Wake-Up Function
NOVA-8890 provides two kinds of Wake up Function.
This page describes how to use Modem Wake-Up and LAN Wake-Up function.
Wake-Up function is enabled when you use ATX power supply.
Wake–Up On Modem (Ring):
You must set the option Resume on Ring of CMOS SETUP to enable this option.
The ATX power supply will be switched on when there is a ring signal detected on
pin “RI” of serial port.
Wake-Up On LAN:
You must set the option Resume on Ring (LAN2) & Resume on LAN (LAN1) of
CMOS SETUP to enable this option.
When your computer is turned off while LAN Link/Active LED is flashing, it
indicates that LAN chip has entered standby mode and waits for Wake-Up signal.
You can use other computers to wake up your computer by sending ID to it.
ID: ID is the MAC address of your system LAN. Every LAN chip has a factory-set
ID, which can be found from network information in WINDOWS.
ID’s format is xxxxxxxxxxxx
Example ID: 009027388320
