IEI Technology NANO-GM45A, User Manual, Page: 55 / 128

NANO-GM45A EPIC SBC
Page 43
Step 1: Install the cooling kit bracket . A cooling kit bracket is installed on the rear of
the motherboard. Align the bracket with the four retention holes at the back of
the motherboard. Once properly aligned, insert four retention screws from the
front of the motherboard.
Figure 4-3: Cooling Kit Support Bracket
Step 2: Open the lever at the top of the heat sink . Lift the lever at the top of the
cooling kit to loosen the cooling kit clamps.
Step 3: Secure the cooling kit . Gently place the heat sink and cooling kit onto the CPU.
Make sure the hooks are properly secured to the bracket. To secure the cooling
kit, close the top lever.
Step 4: Connect the fan cable . Connect the cooling kit fan cable to the fan connector
on the NANO-GM45A. Carefully route the cable and avoid heat generating chips
and fan blades. Step 0:
4.4.3 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-4 .