IEI Technology KINO-SE-i2, User Manual

Page: 70 / 125

KINO-SE-i2
P a g e 58
4.3.2 S in g le RS -232 Ca b le
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
S te p 1:
Locate the connector . The location of the RS-232 connector is shown in
Chapter 3 .
S te p 2:
Insert the cable connector . Insert the connector into the serial port box header.
See Figure 4-3 . A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-3: Single RS-232 Cable Installation
S te p 3: Secure the bracket . The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
S te p 4:
Connect the serial device . Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system.