IEI Technology KINO-DQM871-i1, User Manual

Page: 88 / 160

KINO-DQM871-i1 Mini-ITX SBC
Page 74
Step 3: Connect the cable to the SATA disk . Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-12 .
Step 4: To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable. Step 0:
4.10 IPMI Setup Procedure
The KINO-DQM871-i1 features Intelligent Platform Management Interface (IPMI) that
helps lower the overall costs of server management by enabling users to maximize IT
resources, save time and manage multiple systems. The KINO-DQM871-i1 supports IPMI
2.0 through the optional iRIS-1010 module. Follow the steps below to setup IPMI.
The hardware configuration of the managed system (KINO-DQM871-i1) is described
below.
Step 1: Install an iRIS-1010 module to the IPMI module socket (refer to Section 4.5 ).
Step 2: Make sure at least one DDR3 SO-DIMM is installed on the KINO-DQM871-i1.
Step 3: Connect an Ethernet cable to the RJ-45 connector labeled LAN2 ( Figure 3-33 ).
4.11 Intel
®
AMT Setup Procedure
The KINO-DQM871-i1 is featured with the Intel® Active Management Technology (AMT).
To enable the Intel® AMT function, follow the steps below.
Step 1: Make sure at least one DDR3 SO-DIMM is installed on the KINO-DQM871-i1.
Step 2: Connect an Ethernet cable to the RJ-45 connector labeled LAN1 .
Step 3: The AMI BIOS options regarding the Intel® ME or Intel® AMT must be enabled,
Step 4: Properly install the Intel® Management Engine Components drivers from the
iAMT Driver & Utility directory obtained from IEI Resource Download Center.
See Chapter 6 .
Step 5: Configure the Intel® Management Engine BIOS extension (MEBx). To get into
the Intel® MEBx settings, press <Ctrl+P> after a single beep during boot-up