IEI Technology KINO-DQM871-i1, User Manual, Page: 78 / 160

KINO-DQM871-i1 Mini-ITX SBC
Page 64
Figure 4-4: SO-DIMM Installation
Step 1: Open the SO-DIMM socket handles . Open the two handles outwards as far as
they can. See Figure 4-4 .
Step 2: Align the SO-DIMM with the socket . Align the SO-DIMM so the notch on the
memory lines up with the notch on the memory socket. See Figure 4-4 .
Step 3: Insert the SO-DIMM . Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Figure 4-4 .
Step 4: Removing a SO-DIMM . To remove a SO-DIMM, push both handles outward.
The memory module is ejected by a mechanism in the socket. Step 0:
4.5 iRIS-1010 Module Installation
WARNING:
The iRIS module slot is designed to install the IEI iRIS-1010 IPMI 2.0
module only. DO NOT install other modules into the iRIS module slot.
Doing so may cause damage to the KINO-DQM871-i1.
To install the iRIS-1010 module, please follow the steps below and refer to Figure 4-6 .