IVC-100/120-RS, PM-1056-4P QIG
IVC-200
Connections to the Video Source
Connect your video source to the BNC connector of the video capture card. Take
IVC-100G for example:
x
IVC-100G
LED Jumper Settings
The jumper setting controls the card number on the LED.
Jumper Setting Table
Logic 1 = ON
Logic 0 = OFF
Jump
BNC
LED
Video Source
4
IVC-100/120-RS, PM-1056-4P QIG
1
2
3
4
Card Number on the LED
1 1 1 1
0
0 1 1 1
1
1 0 1 1
2
0 0 1 1
3
1 1 0 1
4
0 1 0 1
5
1 0 0 1
6
0 0 0 1
7
1 1 1 0
8
0 1 1 0
9
1 0 1 0
A
0 0 1 0
B
1 1 0 0
C
0 1 0 0
D
1 0 0 0
E
0 0 0 0
F
Installation Procedures-Driver Installation
IEI driver installation program makes the driver installation of multiple cards
an easy job. The steps of driver installation are described as below:
Steps:
i. Adjust the jumper setting of the video capture card.
ii. Insert the video capture card(s) into the computer system, and then turn on the computer.
iii. The system will find a new device on the system and ask you to install the driver. Click
Cancel to close the dialog box.
iv. Run the program ieisetup.exe from the IEI Installation CD.
v. The window will show a welcome message for installation. Click the Next button for next
step.
vi. The window will then show a message of current configuration, click Next to start the
installation.
vii. The window will show a message to
warn you that the software does not
contain a Microsoft digital signature.
Click Yes to continue the installation.
viii. There will be another window
message to ask you to install an audio
driver. Click Yes to continue.
ix. For multi-card system, you will be
asked to install video and audio
drivers for every card in your system.
Click Yes to continue the installation.
x. After the driver has been successfully installed, click Finish.
xi.
Restart your computer when you finish installing DirectX.
5
