IEI Technology IMBA-C2360-i2, User Manual

Page: 96 / 182

IMBA-C2360-i2 ATX Motherboard
Page 80
4.11.7 USB Power Selection
The USB power selection is made through the BIOS menu in “Chipset
Æ
PCH-IO
Configuration”. Use the USB Power SW1 and the USB Power SW2 BIOS options to
configure the correspondent USB ports (see Table 4-6 ) and refer to Table 4-7 to select
the USB power source.
BIOS Options Configured USB Ports
USB Power SW1
K/M_USB1 (external USB 2.0 ports)
LAN1_USB1 (external USB 3.0 ports)
LAN2_USB2 (external USB 3.0 ports)
USB Power SW2
USB1 (internal USB 2.0 ports)
USB2 (internal USB 2.0 ports)
USB3-1 (internal USB 3.0 ports)
Table 4-6: BIOS Options and Configured USB Ports
Options Description
+5V DUAL +5V dual (default)
+5V +5V
Table 4-7: USB Power Source Setup
Please refer to Section 5.4.2 for BIOS setup.
4.12 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.12.1 SATA Drive Connection
The IMBA-C2360-i2 is shipped with two SATA drive cables. To connect the SATA drives
to the connectors, please follow the steps below.
Step 1: Locate the connectors . The locations of the SATA drive connectors are shown
in Chapter 3 .
Step 2: Insert the cable connector . Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-21 .