IMB-9454G-R40
Page 71
NOTE:
When two IDE disk drives are connected together, back-end jumpers on
the drives must be used to configure one drive as a master and the other as
a slave.
4.5.4.2 Floppy Drive Connector
The floppy drive connector provides access to one externally mounted floppy drive
(3.5”-profile, 1.44 MB type floppy drive).
A 26-pin FPC connector cable is required for the connection to the floppy drive. The cable
should come with a 26-pin FPC-cable connector and floppy disk drive connector on the
other end. Follow the instructions below to connect a floppy disk drive to the motherboard.
Step 1:
Plug the 26-pin FPC-cable connector into FDC1. Make sure that the red wire
corresponds to pin one on the connector.
Step 2:
Attach the appropriate connector on the other end of the cable to the floppy drive.
Only one connector in the set can be used.
Step 0:
4.5.4.3 COM Port Connectors
The IMB-9454G provides six serial ports (COM1, COM2, COM3, COM4, COM5 and
COM6) interfaced through five 10-pin male headers (COM2, COM3, COM4, COM5 and
COM6) and one DB-9 connector (COM1). The serial ports facilitate the connection to
serial devices or a communications network, e.g., terminal console.
Summary of Contents for IMB-9454G-R40
