Page 12
HDC-701EL Video/Audio Capture Card
Before and during the installation of the HDC-701EL,
DO NOT:
Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
Use the product before verifying all the cables and power connectors are
properly connected.
Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
2.3 Video/Audio Capture Card Installation
The HDC-701EL video/audio capture card has a PCIe x1 interface. To install the
HDC-701EL, please follow the steps below:
Step 1:
Align the PCIe edge connector on the bottom of the video/audio capture card
with the PCIe x1 slot on the system motherboard.
Step 2:
Gently insert the video/audio capture card into the PCIe x1 slot.
Step 3:
Push down gently on the video/audio capture card to make sure it is firmly
inserted into the PCIe x1 slot.
Figure 2-1: HDC-701EL Installation
Step 4:
Insert a retention screw through the top of the video/audio capture card external
bracket into the chassis to secure the card to the chassis.
Step 0:
Summary of Contents for HDC-701EL
