IEI Technology GeniSPOT, User Manual, Page: 19 / 71

GeniSPOT Screen Calibration Kit
Page 7
3.1 Installation Overview
Installation includes setting up the hardware and connecting it to the system, installation of
the GeniSPOT drivers and finally, installation of the GeniPASS software.
3.2 Hardware Installation
The GeniSPOT can be installed for a single monitor or multiple monitors. Special
instructions for multiple monitors are noted. To install the GeniSPOT please follow the
directions below:
Step 1: Attach the GeniSPOT sensor holder onto the (primary) monitor. Place the
holder on the top of the (primary) monitor so that the two legs are straddling over
the front and back of the monitor edge and the cable is facing the rear of the
monitor. Turn the screw clockwise to tighten the holder into position.
Figure 3-1: GeniSPOT Holder Attachment
Step 2: Attach the GeniSPOT USB cable to the monitor USB hub, and the monitor
to the computer . Connect the cable from the GeniSPOT to one of the A-series
USB ports on the rear panel of the monitor. Attach the USB B-series connector
of the included cable (included with the monitor) to the USB B-series port on the