IEI Technology ECW-281BB6, User Manual

Page: 69 / 167

ECW-281BB6 Embedded System
Step 3:
Place the HDD into the bracket.
Step 4:
Align the retention screw holes in the HDD with those in the bottom of the
bracket.
Step 5:
Secure the HDD with the bracket by inserting four retention screws into the
bottom of the bracket (
Figure 4-4
).
Figure 4-4: HDD Retention Screws
Step 6:
Locate the breather hole of the HDD. Cut off the corresponding area of the
breather hole from the thermal pad.
Step 7:
Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
breather hole (
Figure 4-5
).
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the breather
hole may cause damage to the HDD.
Page 69