IEI Technology ECW-281BB6, User Manual

Page: 70 / 167

ECW-281BB6 Embedded System
Figure 4-5: HDD Thermal Pad
Step 8:
Replace the HDD bracket onto the bottom surface by aligning the four retention
screw holes in the HDD bracket with those in the back of the bottom surface.
Step 9:
Reinsert the four previously removed retention screws.
Step 10:
Connect the IDE cable connector in the ECW-281BB6 to the HDD.
Step 11:
Replace the bottom surface to the bottom panel by reinserting the six previously
removed retention screws.
Step 0:
4.2.6 Mounting the System with Mounting Brackets
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
Step 1:
Turn the embedded system over.
Step 2:
Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface.
Step 3:
Secure the brackets to the system by inserting two retention screws into each
bracket.
Page 70