IEI Technology ECW-281B-945GSE, User Manual

Page: 146 / 167

ECW-281B Embedded System
Page 130
7.3.1 SO-DIMM Replacement
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the ECW-281B-945GSE. Please make sure the purchased SO-DIMM
complies with the memory specifications of the ECW-281B-945GSE.
To replace a SO-DIMM memory module into a SO-DIMM socket, please follow the steps
below.
Step 1: Remove the bottom surface panel.
Place the ECW-281B-945GSE on an
anti-static pad with the bottom panel facing up and the bottom surface removed.
(see
Section 4.2.3
).
Step 2: Locate the SO-DIMM
(
Figure 7-1
).
Figure 7-1: SO-DIMM Cover Plate
Step 3: Remove the SO-DIMM
by releasing the arms on the SO-DIMM socket.
Step 4: Align the new SO-DIMM with the socket
. The SO-DIMM must be oriented in
such a way that the notch in the middle of the SO-DIMM must be aligned with
the plastic bridge in the socket (
Figure 7-2
).
Step 5: Insert the SO-DIMM
. Push the SO-DIMM chip into the socket at an angle