IEI Technology AFL3-W15C-ULT5-P-PC-4G, User Manual

Page: 60 / 144

AFL3-W15C/W19C/W22C-ULT5 Panel PC
Page 44
3.13.3 Cabinet and Rack Installation
The AFL3-W15C/W19C/W22C-ULT5 flat bezel panel PC can be installed into a cabinet or
rack. The installation procedures are similar to the panel mounting installation. To do this,
please follow the steps below:
NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the AFL3-W15C/W19C/W22C-ULT5 flat bezel
panel PC and the rack/cabinet into which the
AFL3-W15C/W19C/W22C-ULT5 is installed.
Step 1: Slide the rear chassis of the AFL3-W15C/W19C/W22C-ULT5 panel PC through
the rack/cabinet bracket until the frame is flush against the front of the bracket.
Step 2: Insert a M5*50 screw into the screw hole on the side of the rack mounting
bracket. Then, install the following components onto the screw in sequence.
See Figure 3-29 .
Sequence Item Photo Instruction
1 Spring Install a spring onto the screw.
2 Nut Tighten a nut until the spring is
compressed enough for plastic cap.
3 Plastic
cap
Tighten a plastic cap onto the end of
screw thread.
Step 3: Repeat Step 4 to install the other three screws into the sides of the two rack
mounting brackets.