IEI Technology AFL-15A-N270, User Manual

Page: 66 / 158

AFOLUX AFL-15A-N270 Panel PC
Page 66
5.5 Replacing Components
5.5.1 Memory Module Replacement
The flat panel PC is preinstalled with a 1.0 GB DDR2 memory module. If the memory
module is fail, follow the instructions below to replace the memory module.
Step 1:
Remove the back cover. See
Section 5.4.1
above.
Step 2:
Remove the internal aluminum back cover. See
Section 5.4.2
above.
Step 3:
Locate the DDR2 SO-DIMM on the motherboard (
Figure 5-3
).
Figure 5-3: SO-DIMM Socket Location
Step 4:
Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 5:
Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 6:
Install the new DDR memory module by pushing it into the socket at an angle
(
Figure 5-4
).
Step 7:
Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 5-4
).