Hangzhou IECHO Science & Technology Co., Ltd.
6
5.3.
Connection of emergency stop cable
The three-pin plug of the emergency stop cable is connected with the
emergency stop control interface on the outside of the milling tool control box, and
the two-pin plug is connected with the emergency stop control interface of the
milling tool on the electrical box of the cutting machine.
Figure 4 · plug Emergency stop cable into milling tool control box connection
Figure 5 · Connect the emergency stop cable to the electrical box of the machine
5.4.
Gas source connection
Use a 6mm intake pipe to connect the intake end of the filter. The cooling air is
controlled by a solenoid valve. When the milling tool is powered on, the solenoid
valve opens automatically. The output interface is on the outside of the milling tool
control box, and the spindle cooling air is connected through this. (Note: The pipe
connected to the electric spindle is 4mm.)
Gas path
：
①→②→③→④→⑤→⑥
Figure 6 Air connection
6mm pipe
④
6mm pipe
①
4mm pipe
⑤
6mm pipe
②
6mm pipe
③
4mm pipe
⑥
