IDX VL-2PLUS, Service Manual

Page: 5 / 22

NO. XC09T0117
V1.0
4. Operating Instructions
1. When used as a charger
A. Connect AC power cord firmly.
B. Turn the rear mounted power switch ON. (Power LED will light and show solid
Amber)
C. Basic Operation:
1. Connect a battery: “Battery Check Mode” starts, the charge channel LED will
show solid Red while the charger is checking the battery.
2. Battery Check: After 3 seconds the LED will remain Red indicating that the
VL-2PLUS is operating in quick charge mode, if a battery has a fault the LED will
flash Amber. If a battery cannot be recovered or is detected as over-charged, the
LED will flash Amber indicating a battery fault.
3. Charge Complete: When a battery has been fully charged, the charge channel
LED will automatically change to solid Green, indicating the battery is ready.
4. Remove the battery by pushing down either of the Release Levers located on
each channel. For NP-type battery removal, hold the charger to secure it and pull
the battery our straight.
2. When used as AC Adaptor
1. Connect the power cord firmly.
2. Turn the power ON. (Power LED will light and show solid Amber)
3. Power is supplied to the connected equipment by DC-OUT from the 4 pin XLR
output connector. (output voltage is 13.8V)
5. Features
- Can charge IDX ENDURA System Li-ion batteries. (All IDX NP-type Li-ion / Ni-Cd
batteries via optional A-E2NP Charge Adaptor)
- Quick charging on both channels sequentially.
- Built in 60W Camera Power Supply
- Auto safety & protection features for damaged or misused batteries.
- Robust light weight polycarbonate case. Recessed or power switch, built-in AC line
spare fuse, convenient carrying handle.
- Automatic Universal AC input for world-wide use.
- Can be operated in either horizontal or vertical position.
4
Model: VL-2PLUS IDX Company, Ltd.