IDX CW-1dx, Instruction Manual

Page: 12 / 36

Explanation of each part
・
Link LED
This indicator shows Link status of Transmitter (TX) and Receiver (RX).
LED blink: searching
LED light lit: linked
・
Video LED
This indicator shows video status.
LED off: no video signal / abnormal status
LED blink: searching
LED lit: linked
・
Digital LED display
This digital LED shows current setup status.
H: under activation
U: under software upgrade
1: setup to 5180MHz
2: setup to 5240MHz
3: setup to 5765MHz
4: setup to 5805MHz
・
CH Button
Press for 1sec.: This is to change CH as below.
1→2→3→4→1→…→
Press and hold for 3sec.:
This is only required for service maintenance purpose,
and paring mode (pair up SSID and Password for each TX and RX).
・
Mode Button
Press and hold for 3sec.: This will change the MODE as below.
Normal Mode
：
HDMI Video Transmission Mode
*Link LED & Video LED turn to RED
RTSP Mode
：
Streaming Mode
*Link LED & Video LED turn to Yellow
**Video signal of HDMI output from RX is automatically regulated to 720P
output only during RTSP Mode
The device reboots automatically when Mode change is made.
11