Innovative DisplayWorks
G-10f/GCG-10f
8 Remove door limit from right hinge into corresponding
holes on left hinge.
9 Feed the wiring terminals through the hinge and connect
the terminals.
10 Reinstall the torsion rod into the new
position of the door axis.
11 Set the upper hinge into the torsion rod at approximately a
60°angle. Rotate the hinge to the right counter-clockwise
aligning the holes in the bracket with the holes on top of
the cabinet.
12 Install the limit to the door. Installing sequence—the
wave washer—gasket-limit-bolt
13 Check to ensure the door is securely attached and
functioning properly.
14 Attach the front grill to complete the door reversal
process.
DOOR REVERSAL Cont. (For G-10f Coolers Only)
12
door s reserved hole,then get through hinge axie, connect
the terminals.
10.assemble the front grill, complete the reversible door
exchange.
9.fix the upper hinge into left axie sleeve, then
anticlockwise rotate the hinge to right position to fasten
it.
8.clockwise rotate the left axie sleeve 60°.
8.Remove door limit from right hinge into
corresponding holes on left hinge
9.Feed the wiring terminals through the
hinge and connect the terminals.
12.Install the limit to the door.
Installing sequence：the wave
washer—gasket-limit-bolt
6
7
10. Reinstall the torsion rod into the new
position of the door axis.
11. Set the upper hinge into the torsion
rod at approx a 60°angle. Rotate the hinge
to the right counter clockwise aligning the
holes in the bracket with the holes on top
of the cabinet.
wiring is stretching out from the bottom
of the door left
7. Remove the hinge axis from the right
bottom hinge, inert it into the left bottom
hinge.
