iDTRONIC BLUEBOX ADVANT UHF, Manual, Page: 13 / 54

B5U033000E Page 13 of 54
3.2 Configuration Parameters
This section provides details on the configurable operational parameters of the
BLUEBOX .
3.2.1 CAN Bus Interface
The CAN bus interface parameters are managed through OD 1014h, 1015h,
20F0h and 20F2h as described in protocol technical manual.
The changed CAN bus interface parameters become effective only
after a reset of the BLUEBOX . Reset the BLUEBOX using the
‘Reset Device’ command or via a hardware reset.
3.2.2 RF and EPC C1G2 (Class-1 Generation-2)
This section provides details on the configurable RF and EPC C1G2 (Class-1
Generation-2) parameters of the
BLUEBOX
The RF parameters are managed through the OD 2201h.
Value Definition:
Sub-index 00h contains the number of valid object entries within the record. The
number of valid objects entries shall be the number of the general configuration
parameters. Its value is 08h.
Sub-index 01h to 08h contains a configuration parameter. An attempt to change
the value of the configuration parameter to any not supported value shall be
responded with the SDO abort transfer service (abort code: 06090030h). See
the
BLUEBOX user manual for value definition details.
Parameter Description Range Default
RF
Geographical
Region
RF geographical region.
Note that ETSI, FCC and Brazil readers cannot
be altered and only operate per the regulatory
laws in USA/Canada, the European Union and
Brazil.
EU1: ETSI
FCC: FCC
BRA: Brazil
EU1: ETSI
FCC: FCC
BRA: Brazil
RF Trasmit
Power
RF conducted transmit power in dBm.
Refer to country specific regulations for
limitations. You, the user, are responsible to
ensure operation with the correct RF settings and
are solely responsible for any fines and other
0 … 24 dBm 20 dBm