IDTECH SmartPIN L100, User Manual

Page: 48 / 76

Page | 48
8.9.15 Real Time Key Press Support
This command sets output data content for the Get PIN , Get Numeric Key , and Get Amount commands.
Command Body: 75 46 25 & <1-byte parameter>
Where:
•
Parameter = 0: when a Get PIN , Get Numeric Key , or Get Amount command is executed, the
device outputs “06 57 46 50 47” in hex data when a key is pressed; the device outputs an
encrypted pin block or whole numeric key sequence when enter key is pressed.
•
Parameter = 1: when a Get PIN , Get Numeric Key , or Get Amount command is executed, the
device outputs the related ASCII code data when a key is pressed (‘0~9’,’B’,’C’,’E’). The device
does not output whole numeric key sequence when the enter key is pressed. If executing a Get
PIN
command, the device outputs ‘*’ as numeric, ‘B’, ‘C’, ‘E’ when the related key is pressed,
and sends an encrypted pin block when Enter is pressed.
Bits Description
bit 7
0: Device will output “06 57 46 50 47” Hex data when a key is pressed.
1: Device will not output any key event.
bit 6 ~
bit 3
Reserved
bit 2
0: When Get PIN from Host command is executed, the device output will follow the configuration of bit 7.
And will output encrypted pin block when enter key is pressed.
1: When Get PIN from Host command is executed, the device will output the related ASCII code data
when a key is pressed (‘*’ for digital key, ’B’,’C’,’E’). And send encrypted pin block when enter key is
pressed.
Note: Bit 2 can be ignored when the L100 is used with a VP5300 reader.
bit 1
0: When Get PIN from CR command is executed, the device will not output any key event when key
pressed (Special for the requirement of Spectrum Pro/VP5300). And will output encrypted pin block when
enter key is pressed.
1: When Get PIN from CR command is executed, the device will output the related ASCII code data when a
key is pressed (‘*’ for digital key, ’B’,’C’,’E’). And send encrypted pin block when enter key is pressed.
bit 0
0: When Get numeric/Get amount command is executed, the device output will follow the configuration
of bit 7. And will output whole numeric key sequence when enter key is pressed.
1: When Get numeric/Get amount command is executed, the device will output the related ASCII code
data when a key is pressed (‘0~9’,’B’,’C’,’E’). And won’t output whole numeric key sequence when the
enter key is pressed.
8.9.16 Get Numeric with Display Message
Command Body: 75 46 08 & <256 bytes Encrypted Display Message>
Where:
•
<256 bytes Encrypted Display Message> is the encrypted plaintext display message by numeric