2.2.
Mode 2 - Erase
Mode 2 is used to erase detectors from the IDS Xwave 8 Channel Standalone Wireless
Receiver.
To erase a detector from the IDS Xwave 8 Channel Standalone Wireless Receiver:
1.) Hold the MODE button until LED 2 is lit, then release it.
2.) Choose the channel you want to erase the detector from, this is done by holding the
MODE button again until the desired LED is lit.
(If there is a detector learned to that channel the LED will begin flashing)
3.) After approximately 10 seconds all zone LEDs will flash momentarily. This indicates
that the detector in selected channel has been erased.
4.) You can erase another detector by pressing the MODE button until the desired LED
is lit and repeating the process.
2.3.
Mode 3 - RSSI
RSSI mode is used to test the signal strength of a detector.
To check the signal strength of a detector on the IDS Xwave 8 Channel Standalone
Wireless Receiver:
1.) Hold the MODE button until LED 3 is lit, then release it.
2.) Choose the channel you want to check the signal strength of, this is done by
holding the MODE button again until the desired LED is lit.
3.) Trigger the detector learned to the selected channel. The zone LEDs will light up
proportional, to that detectors signal strength.
(The LEDs light from left to right, so if only two LEDs on the left are illuminated your
signal is poor, if you have 6 LEDs illuminated your signal is good)
4.) You can check the signal strength of another detector by pressing the MODE button
until the desired LED is lit and repeating the process.