1.5.
LEDs
The IDS Xwave 8 Channel Standalone Wireless Receiver uses LEDs to indicate what is
happening on the receiver.
Power LED - This LED is on when the receiver is powered.
Zone LEDs - LEDs 1 - 8 will light up when the receiver has received a signal from the
corresponding detector, and to indicate which menu option has been chosen.
RF Jam LED - Zone LED 8 will come on when the receiver has detected an RF Jam.
Tamper LED - This LED will come on if the receiver gets a tamper signal from one of
the learned detectors, or if the box tamper has been triggered. The LED will turn off
once it has received a tamper restoral from the tampered detector.
Supervision - This LED will come on if the receiver has not received a signal from a
specific detector within the Supervision time. The LED will turn off once the receiver has
received a signal from that detector.
Low Battery - This LED will turn on if the receiver gets a low battery signal from a
detector. The LED will turn off once it receives a battery restoral from that same
detector.
2.
Modes
To program the IDS Xwave 8 Channel Standalone Wireless Receiver ensure that
jumper 3 is off, so that the tamper switch becomes the MODE button. Programming is
done by holding the MODE button down, the zone LEDs will light up one at a time
starting from 1 up until 8. Release the MODE button when the LED reaches the mode
you need. After 2 minutes of inactivity the receiver will return to normal operation.
2.1.
Mode 1 - Learn
Mode 1 is used to learn detectors into the IDS Xwave 8 Channel Standalone Wireless
Receiver.
To learn a detector to the IDS Xwave 8 Channel Standalone Wireless Receiver:
1.) Hold the MODE button until LED 1 is lit, then release it.
2.) Choose the channel you want to learn the detector to, this is done by holding the
MODE button again until the desired LED is lit.
(If there is already a detector learned to that channel the LED will begin flashing. You
can learn a new detector to replace the existing one)
3.) Press the tamper on the detector you want to learn to the selected channel. When
the detector has been learned all zone LEDS will flash momentarily.
4.) You can learn another detector by pressing the MODE button until the desired LED
is lit and repeating the process.