IDS MKII, Installer Manual

Page: 5 / 16

IDS Digital Remote Receiver MKII 700-373-02C Issued April 2010 5
1.4 Electrical Specifications
Supply Voltage: 10 to 15 V
DC
Current Consumption: 30mA
Relay Rating Contacts: 1 A @ 30 V
DC
Minimum Receiver Sensitivity: ≤ -100 dBm
Receiver Frequency: 433.92 MHz
1.5 DIP Switches
There are no jumpers on this receiver, as the 6-pin dual in-line connector is used for version updates.
All of the programming is performed via DIP switches (1 - 8). These are used for programming the
functionality of the receiver, to learn remote buttons, change operating parameters, and to set the mode
of operation. These instructions use the terms “SET” and “CLEAR” to refer to the position of the relevant
DIP switches.
(Set = On, Clear = Off.)
During normal operation (STANDBY MODE) all switches are cleared , except the two that are used to
select STANDBY MODE options - see page 16 “Selecting Standby Mode” for more details on these
options.
DIP switches
Standby Mode 1 2 3 4 5 6 7 Default Settings
Panic Disable 0 0 0 0 0 0 1 Panic active when switch is OFF
Arm Protect 0 1 0 0 0 0 0 Prevents arm & stay arm signal re-
triggering for 20 second period
Standby Mode 0 0 0 0 0 0 0
1.6 LED Indication
There are three LEDs on the receiver PCB. A red, a green and an amber LED.
The amber LED is on when there is a satisfactory bus connection between the receiver and the Alarm
Panel.
The red and green LEDs can display a multitude of different signals to indicate receiver status. A full table
of red and green LED indications is included on page 13.