NJR-T04HD / NJR-R04HD User’s Guide
50
10.2.6 Setting display size
You can set the display size of input video.
The video size is scaled based on the upper left quadrant of the input video.
【
Setting for
NJR-T04HD: For each HDMI input connector, each input signal
If “
10.11.1 Devices to be connected
” is set to “NJR-T01UHD or NJR-R01UHD is included”
or “
” is set to “All Inputs”, @SNS communication command cannot be
used.
NJR-R04HD: For each HDMI output connector
For outputs whose “
10.2.12 Videowall enabled / disabled and coordinate grid
” is set to
“Enabled”, the setting of OUT1 will be applied.
Display size can be set for each output separately, in the following cases. However, if
reduction ratio is not the same, the smallest reduction ratio will be applied.
▪
An NJR-T01UHD is used as a transmitter and 4K video is input.
▪
An NJR-T04HD is used as a transmitter and “
10.11.1 Devices to be connected
is set to “NJR-T01UHD or NJR-R01UHD is included” and “
” is
set to IN1 to IN4.
Settings for when videowall is enabled and for when videowall is disabled can be kept
individually.
Setting value
Horizontal display size
[Table 10.10] Setting horizontal display size
Model
Set value
Default
NJR-T04HD All Inputs
1920÷4 to 1920×4
1920
Input video of IN1 to IN4
Horizontal input resolution÷4 to
horizontal input resolution×4
Horizontal input
resolution
NJR-R04HD
－
Horizontal output resolution÷6
to horizontal output
resolution×6
Horizontal
output
resolution
Vertical display size
[Table 10.11] Setting vertical display size
Model
Set value
Default
NJR-T04HD All Inputs
1080÷4 to 1080×4
1080
Input video of IN1 to IN4
Vertical input resolution÷4 to
vertical input resolution×4
Vertical input
resolution
NJR-R04HD
－
Vertical output resolution÷6 to
vertical output resolution×6
Vertical output
resolution
Communication command
@SNS Setting display size
@GNS Getting display size
NJR-T04HD / NJR-R04HD
