MSD-804FD
User’s Guide
123
7.9
EDID (Extended Display Identification Data)
You can select the EDID from either the built-in data or the data loaded from the connected display device.
The MSD can load EDID that conforms to VESA DDC2B/EDID standard ver. 1.0 to 1.3.
Note:
For PCs, since EDID is acquired when the PC is turned on, turn on the PC while the MSD and display device
are turned on. When turning off the system, first turn off the PC and then turn off the MSD and display device.
If you change the settings of EDID during operation, the MSD may not be recognized correctly. Set EDID
while source devices are turned off as much as possible.
7.9.1
EDID setting [EDID DATA]
You can set the EDID to be sent to the connected source device.
If you select “INTERNAL EDID”, the EDID
that is set in the following menus is sent:
“7.9.2PC resolutions [PC RESOLUTION]”, “
for AV devices [AV RESOLUTION]
7.9.4 Deep Color [DEEP COLOR INPUT]
7.9.6 Speaker configuration [SPEAKER]
･
Built-in data: INTERNAL EDID [Default]
･
Data of display device connected to HDMI output connector: OUTn MONITOR
*1
･
Data copied from display device: COPY DATA 1 to 8
*2
*1
“n”: Output number: 1A to 4A, 1B to 4B
1B to 4B are available only if HDBaseT option is mounted.
*2
EDID must be loaded from the display device set in ”
“ beforehand.
For each input
