COS-100HD-B Command Guide
8
■
To enable “Setting mode”
1
Place control device, transmitter or receiver, and then connect them using an RS-232C cable.
2
Power on each device.
3
Set the RS-232C communication mode of the transmitter and receiver to “Setting mode”.
*1
Set [F99] (Maintenance/Status display menu) to “on” or “ALL” (Always displayed).
Set [C13] (RS-232C communication mode) to “01” (setting mode).
4
Set the RS-232C communication settings between transmitter and receiver.
*2
Set “[C14]” (RS-232C communication baud rate) depending on the control device.
Set “[C15]” (RS-232C communication data bit) depending on the control device.
Set “[C16]” (RS-232C communication parity check) depending on the control device.
Set “[C17]” (RS-232C communication stop bit) depending on the control device.
5
Execute the desired command.
【
See: 3.3 Detailed descriptions
6
Set “[F99]” (Maintenance/Status display menu) to “oFF” (Not displayed) as needed.
*1
If the RS-232C communication settings between control device and transmitter/receiver are set correctly,
the RS-232C communication mode can be set using (@S*S) command.
【
See: @S*S
*2
If the RS-232C communication settings between control device and transmitter/receiver are set correctly,
the RS-232C communication can be set using (@SCT) command. If changing RS-232C communication
setting, change the control device setting.
【
See: @SCT / @GCT