COS-100HD-B Command Guide
16
■
To enable “Transmission mode”
1
Place control device, transmitter and receiver, external device and then connect them using an
RS-232C cable.
2
Power on each device.
3
Enable “Setting mode” of the transmitter and receiver and set the RS-232C communication.
For RS-232C communication, see the “
3.1 Controlling transmitter or receiver
”.
4
Set the RS-232C communication mode of the transmitter and receiver to “Transmission mode”.
*
Set [F99] (Maintenance/Status display menu) to “on” or “ALL” (Always displayed).
Set [C13] (RS-232C communication mode) to “00” (transmission mode).
5
Set “[F99]” (Maintenance/Status display menu) to “oFF” (Not displayed) as needed.
*
If the RS-232C communication settings between control device and transmitter/receiver are set correctly,
the RS-232C communication mode can be set using (@S*S) command.
【
See: @S*S
