Part 1 – Introduction
12
Installation
Installation of this product does not require the use of
special tools.
For more information on other devices comprising the
overall system, refer to their respective
installation
manuals
.
Product color and design may vary depending on the
model.
Inserting a SD Memory Card
Insert a SD memory card into the SD memory card slot
with the 'micro SD' print facing upward.
micro
SD
Push the SD memory card until it disengages from the
slot, and then pull it out.
Make sure that the cover is joined properly when
screwing it; otherwise, the IP66 level is not guaranteed.
Installation
•
Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
•
Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
1
Make a cable hole in the wall or ceiling.
Apply glue
to the gaps
Pendant
Bushing
Bushing
Use a bushing provided with the camera to prevent
moisture or water from entering through the bracket
or pipe. First, pass the cable through the waterproof
bushing, assemble it in the pendant, and then use the
waterproof glue provided with the camera to fill the
cable gap and the holes.
1-1/2" Bracket
Mount Adapter
Pendant
<Installing to the bracket>
<Installing to the Pipe>
2
When installing in 1-1/2" PF bracket, assemble
mount adapter to the bracket and then assemble
the pendant. Hook the safety wire of the camera on
the safety wire ring of the bracket.
The bracket must be purchased separately.
