Part 1 - Remote Setup
22
•
IR Cut Filter
: IR Cut Filter blocks out the infrared
spectrum. You can ensure clear images at all times by
blocking out the infrared spectrum in high-lighting
conditions and allowing the infrared spectrum to pass
through in low-lighting conditions. When configuring
Event > Alarm In
, this feature will not function if
Day
& Night Mode
event action has been configured.
-
Nighttime Mode / Daytime Mode
: Disable or
enable IR Cut Filter.
-
Auto
: Allow the system to enable/disable IR Cut
Filter automatically.
-
Schedule
: Set up an IR Cut Filter schedule. IR
Cut Filter use is disabled during dates and times
designated as
Nighttime
and enabled at all
other times. Select
On
or
Off
at the bottom of the
schedule table and then click or drag on the dates
and times to select/unselect as
Nighttime
. Select
On
or
Off
and then click
Select All/Clear All
to
select/unselect all dates and times as Nighttime.
Miscellaneous
Configure
Miscellaneous
settings.
•
Video Output
: Select a video output signal format.
Streaming
•
Primary, Secondary, Tertiary
: Multistreaming is
supported. (priority: Primary > Secondary > Tertiary).
Enable/disable streaming use. The lower stream
settings may change depending on higher stream
settings. The tertiary stream may not be available
depending on higher stream settings (refer to the
table below).
Model
Primary
Secondary
Tertiary
Resolution
ips
Resolution
ips
Resolution
ips
DC-B1001
704x480
30
704x480
15
-
-
DC-B1103 /
DC-B1101
1280x720
30
1280x720
15
-
-
DC-B1203
1920x1080
30
704x480
30
-
-
DC-B1303
2304x1296
15
1280x720
15
1280x720
15
•
Compression
: Choose the streaming compression
method.
•
Resolution
: Choose a resolution setting for video
streaming. The current stream resolution cannot be
higher than the higher stream resolution.
