iDirect Evolution X3 Satellite Router Installation and Safety Manual
23
Preparing the Coax Cables
Before you can connect the cables, you must install connectors on each end.
To terminate the cables with F-Type connectors:
1
Cut off each end of the coax cable squarely, using the proper cable cutter.
Figure 9 Coax Cable Cutting Technique
2
Remove the jacket material and foam insulation according to the length defined under
Length A in
Table 9
. For RG-6, use a two-step Coax Stripper such as the LC-CST 1257 from
Paladin Tools.
3
Remove any foil in the braid.
Wear protective eye wear while cutting cables and terminating
connectors. Ensure that the center conductor is straight and cylindrical
without any burrs. Failure to do so can damage the IDU, BUC, and/or LNB
input connector.
Table 9 Coax Trim Dimensions
Length A
(inch (mm))
Length B
(inch (mm))
Length C
(inch (mm))
RG-6
5/8 (15.9)
1/4 (6.4)
3/8 (9.5)
RG-11
13/32 (10.3)
3/32 (2.4)
13/32 (10.3)