Idex Hale Sam, Technical Manual

Page: 72 / 223

52
Figure 34. SAM Control Panel R&R
Installation
THE CONTROLLER UNIT DEUTSCH CONNECTORS ARE KEYED TO PREVENT INTER-
CHANGE OR REVERSE DIRECTION INSERTION. DO NOT FORCE A CONNECTOR WITH-
OUT FIRST VERIFYING THE CONNECTORS ORIENTATION AND PLACEMENT.
NOTE
SAM Control Center orientation is connectors toward the bottom of the panel.
A. From front of panel, align new SAM Control Center with opening in panel. See Fig-
ure 34.
B. From rear of panel, place bracket over rear of SAM Control Center. See Figure 34.
C. Support SAM Control Center and bracket; hand start four [4] 8-32 x 1/2-in long
screws (each with a lock washer). See Figure 34.
D. Using 5/64-in hex socket and ratchet (set CW) (or Allen key), tighten four [4]
screws.
E. Connect electrical connectors according to tags (including all plugs).
F. Install cable ties cut to R&R SAM Control Center as noted.
G. If master SAM Control Center, perform SAM Control Center Master Assignment.
(See paragraph 4.12.2, page 132).
H. If master SAM Control Center, perform Wi-Fi setup.
(See paragraph 4.12.2, page 131.)