Idex Hale Sam, Technical Manual

Page: 151 / 223

131
N. Connect all air lines according to notes/tags.
O. Install all cable ties cut to R&R PF valve.
Perform the Installation portion of paragraph 4.9.2 (page 103), Priming Feature Assembly.
4.12.
Post Removal And Replacement Configuration Procedures
Following the R&R of specific SAM components, configuration/settings require change/update.
Perform the referenced configuration procedure, then perform all referenced adjustments, SAM
setup/configuration, and/or post R&R Testing before returning the apparatus to service.
4.12.1
Enable Master SAM Control Center Wi-Fi
Perform all of paragraph 4.12.1 (above) prior to performing the following.
NOTES
If replacing the SAM Control Center on the main pump panel (the only Wi-Fi capable
screen), the new touchscreen comes from Hale preconfigured to pair with your router.
Please contact Hale Customer Service (800-533-3569) and provide the information
from your Hale ID tag.
Reference the SAM OIM (FSG-MNL-00210), SAM Numbering and Specifications Refer-
ences (paragraph 2.1), Hale ID Tag With Sample Markings (Figure 1) for detailed
Hale ID tag information.
Perform the following to enable the SAM Control Center Wi-Fi.
A.
Power SAM system on.
B. Go to Systems Options screen as follows.
Preform Accessing SAM Password Screens (see paragraph 2.6.1, page 33).
Preform SAM Control Center Password Screen (see paragraph 2.6.1.1, page 34).
Enter user/dealer password. (See Table 2, page 35.)
C. Touch BAM tab.
D. Touch Configuration Mode button. (The Select DEVICE MENU screen is displayed,
see Figure 148, page 188.)
TOUCH ONLY THE SPECIFIED BUTTON(S). FAILURE TO PERFORM THIS PROCEDURE
CORRECTLY MAY CAUSE SAM TO BECOME INOPERATIVE.
E. At top center of screen, touch icon. (MENU screen is displayed, see Fig-
ure 101.)
F. At bottom right of screen, touch This Screen is Wi-Fi Capable check box. (Ensure
check mark appears in check box.)
NOTES
If the This Screen is Wi-Fi Capable check box is NOT displayed, verify the touchscreen
is the correct P/N. Inspect the touchscreen serial number to verify it ends with -TCLS.
Contact Hale Customer Service (800-533-3569), if the new SAM Control Center serial
number does NOT end with -TCLS, or if the This Screen is Wi-Fi Capable check box is
NOT displayed.