Idex Hale Sam, Technical Manual

Page: 138 / 223

118
Place first 6–32 X 1/2-in mounting screw in easiest to access corner of circuit breaker
box.
Using #2 Phillips screwdriver, hold screw in place while mounting circuit breaker box
onto bracket with screw thru associated hole in bracket.
Place new locking nut against screw and start screw into nut, do NOT tighten.
Place next screw into next corner of circuit breaker box, using #2 Phillips screwdriver,
push screw thru box and bracket, then start new locking nut on screw.
Repeat to install the remaining two screws and nuts.
Using #2 Phillips screwdriver and 1/4-in wrench, tighten all four [4] screws.
G. Install cover.
H. Using #2 Phillips screwdriver, install four [4] cover screws.
I. Connect electrical connectors and wires according to tags.
J. Install cable ties cut to R&R circuit breaker box as noted.
Verify the SAM system is functional and ready for service. See paragraph 4.17, page 171.
4.10.6.1.1
Legacy Circuit Breaker Junction Box
The legacy circuit breaker junction box primarily applies to Q series pumps. The circuit breaker
junction box is attached to the Autolube keep out bracket for these legacy SAM systems. See Fig-
ure 86.
Figure 86. Legacy CB Junction Box Location