Idex Hale Sam, Technical Manual

Page: 113 / 223

93
Figure 67. MatrIIX Pressure Governor Module
Figure 68. Governor Module Interface Layout
The matrIIx/pressure governor module installs on the Hale provided bracket located on the front
of the pump directly above the circuit breaker box and Autolube assemblies (right most module).
Connect the module according to Table 48.
Table 48. MatrIIx/Pressure Governor Module Wiring (From/To Listing)
Module Connector/Pin (From) Sensor Connector/Pin (To)
A Keyed Connector (Mates with Grey Harness Connector)
1 (Power) [Input] Circuit Breaker Box, Connector 1 Pin 3
2 (CAN High) [Buss] Green CAN Bus Connector
3 (CAN Shield) [Buss] Green CAN Bus Connector
4 (Pump Engaged Interlock) [Input] OEM Connection To Apparatus
5 (Throttle Interlock) [Input] OEM Connection To Apparatus
6 (Auxiliary Interlock) [Input] OEM Connection To Apparatus
7 (Delay Relay Common) [Input] N/C
8 (Delay Relay Normally Open) [Output] N/C
9 (Alarm Out) [Output] N/C
10 (Auxiliary Input/Output) [I/O] N/C
11 (CAN Low) [Buss] Green CAN Bus Connector
12 (Ground) [Input] Main Ground Stud (On Pump Body)